Reference Guide

Parameters
group (OPTIONAL) Enter the multicast group address in dotted decimal
format (A.B.C.D).
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the S-Series.
Usage
Information
If you use this command on a local VLT node, all multicast routes from the local PIM TIB, the
entire multicast route table, and all the entries in the data plane are deleted. The local VLT
node sends a request to the peer VLT node to download multicast routes learned by the peer.
Both local and synced routes are removed from the local VLT node multicast route table. The
peer VLT node clears synced routes from the node.
If you use this command on a peer VLT node, only the synced routes are deleted from the
multicast route table.
debug ip pim
View IP PIM debugging messages.
S4820T
Syntax
debug ip pim [bsr | events | group | packet [in | out] |
register | state | timer [assert | hello | joinprune |
register]]
To disable PIM debugging, use the no debug ip pim command or use the undebug
all to disable all debugging command.
Parameters
bsr (OPTIONAL) Enter the keyword bsr to view PIM Candidate RP/BSR
activities.
events (OPTIONAL) Enter the keyword group to view PIM messages for a
specific group.
group (OPTIONAL) Enter the keyword group to view PIM messages for a
specific group.
packet [in | out] (OPTIONAL) Enter the keyword packet to view PIM packets. Enter
one of the optional parameters:
• in: to view incoming packets
• out: to view outgoing packets
1026