Reference Guide

Reply to request 5 from 172.31.1.87 0 ms
FTOS#
Example (IPv6)
FTOS#ping 100::1
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 100::1, timeout is 2 seconds:
!!!!!
Success rate is 100.0 percent (5/5), round-trip min/avg/max =
0/0/0 (ms)
FTOS#
reload
Reboot FTOS.
S4820T
Syntax
reload [conditional nvram-cfg-change]
Parameters
conditional
nvram-cfg-
change
Reload if the condition is true. A configuration change to the nvram
requires a switch reload. To reload the switch, select nvram-cfg-
change .
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.1(0.0) Added ‘conditional’ parameter.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
If there is a change in the configuration, FTOS prompts you to save the new configuration. Or
you can save your running configuration with the copy running-config command. Use
the conditional parameter if any configuration changes made to the nvram, such as stack-
group and fanout configurations, must be saved.
Related
Commands
• reset — resets a line card, RPM, or a failed SFM (TeraScale and ExaScale).
• reset stack-unit — resets any designated stack member except the management unit.
104