Reference Guide

• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.4.1.1 Introduced on the E-Series ExaScale.
Usage
Information
The following describes the show ip pim snooping interface commands shown in
the following example.
Field Description
Interface Displays the VLAN interfaces with PIM-SM snooping enabled.
Ver/Mode Displays the PIM version number for each VLAN interface with PIM-
SM snooping enabled:
• v2 = PIM version 2
• S = PIM Sparse mode
Nbr Count Displays the number of neighbors learned through PIM-SM snooping
on the interface.
DR Prio Displays the Designated Router priority value configured on the
interface (ip pim dr-priority command).
DR Displays the IP address of the Designated Router for that interface.
Example (#2)
FTOS#show ip pim snooping interface
Interface Ver Nbr DR DR
Count Prio
Vlan 2 v2 3 1 165.87.32.2
show ip pim snooping neighbor
Display information on PIM neighbors learned through PIM-SM snooping.
S4820T
Syntax
show ip pim snooping neighbor [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display information about PIM
neighbors that PIM-SM snooping discovered on a specified VLAN.
The valid VLAN IDs range is from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
1042