Reference Guide

Outgoing interface list:
GigabitEthernet 8/0
show running-config pim
Display the current configuration of PIM-SM snooping.
S4820T
Syntax
show running-config pim
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.4.1.0 Introduced on the E-Series ExaScale.
Example
FTOS#show running-config pim
!
ip pim snooping enable
Related
Commands
ip pim snooping — enables PIM-SM snooping.
IPv6 PIM-Sparse Mode Commands
The following describes the IPv6 PIM-sparse mode (PIM-SM) commands.
ipv6 pim bsr-border
Invoke IPv6 PIM debugging.
S4820T
Syntax
debug ipv6 pim [bsr | events | group group | packet | register
[group] | state | | timer [assert | hello | joinprune |
register]]
To disable IPv6 PIM debugging, use the no debug ipv6 pim command.
Parameters
bsr (OPTIONAL) Enter the keyword bsr to invoke debugging of IPv6 PIM
Candidate RP/BSR activities.
1049