Reference Guide

events (OPTIONAL) Enter the keyword events to invoke debugging of IPv6
PIM events.
group group (OPTIONAL) Enter the keyword group then the group address to
invoke debugging on that specific group.
packet (OPTIONAL) Enter the keyword packet to invoke debugging of IPv6
PIM packets.
register [ group ] (OPTIONAL) Enter the keyword register and optionally the group
address to invoke debugging of IPv6 PIM register messages for a
particular group.
state (OPTIONAL) Enter the keyword state to view IPv6 PIM state
changes.
timer [assert |
hello | joinprune |
register]
(OPTIONAL) Enter the keyword timer to view IPv6 PIM timers. Enter
one of the optional parameters:
• assert: to view the assertion timer
• hello: to view the IPv6 PIM neighbor keepalive timer
• joinprune: to view the expiry timer (join/prune timer)
• register: to view the register suppression timer
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
ipv6 pim bsr-candidate
Configure the router as a bootstrap (BSR) candidate.
S4820T
Syntax
ipv6 pim bsr-candidate interface [hash-mask-length] [priority]
To disable the bootstrap candidate, use the no ipv6 pim bsr-candidate command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel then a number.
1050