Reference Guide

Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.1.0 Introduced
Usage
Information
Do not enter this command before creating the access-list.
ipv6 pim query-interval
Change the frequency of IPv6 PIM router-query messages.
S4820T
Syntax
ipv6 pim query-interval seconds
To return to the default value, use the no ipv6 pim query-interval seconds
command.
Parameters
seconds Enter a number as the number of seconds between router query
messages. The range is from 0 to 65535. The default is 30 seconds.
Defaults 30 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
ipv6 pim register-filter
Configure the source DR so that it does not send register packets to the RP for the specified sources and groups.
S4820T
Syntax
ipv6 pim register-filter access-list
Parameters
access-list Enter the name of the extended ACL that contains the sources and
groups to filter.
1053