Reference Guide

Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-7.7.1.0 Introduced on the E-Series.
Usage
Information
The monitor command is saved in the running configuration at Monitor Session mode level
and can be restored after a chassis reload.
Example
FTOS(conf)# monitor session 60
FTOS(conf-mon-sess-60)
Related
Command
show monitor session — displays the monitor session.
show running-config monitor session — displays the running configuration of a monitor
session.
show config
Display the current monitor session configuration.
S4820T
Syntax
show config
Defaults none
Command Modes MONITOR SESSION (conf-mon- sess-session-ID )
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Example
FTOS(conf-mon-sess-11)#show config
!
monitor session 11
source GigabitEthernet 10/0 destination GigabitEthernet
10/47 direction rx
FTOS#
1065