Reference Guide

show running-config monitor session
Display the running configuration of all monitor sessions or a specific session.
S4820T
Syntax
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use the show running-
config monitor session command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range from 0
to 65535.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant
FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
The monitoring command is saved in the running configuration at the Monitor Session
mode level and can be restored after a chassis reload.
Example
FTOS#show running-config monitor session
!
monitor session 8
source GigabitEthernet 10/46 destination GigabitEthernet
10/1 direction rx
!
monitor session 11
source GigabitEthernet 10/0 destination GigabitEthernet
10/47 direction rx
FTOS#show running-config monitor session 11
!
monitor session 11
source GigabitEthernet 10/0 destination GigabitEthernet
10/47 direction rx
1067