Reference Guide

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
Version 7.6.1.0 Introduced on the S-Series and C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
On 40-port 10G linecards, if the traffic is shaped between 64 and 1000 Kbs, for some values, the
shaped rate is much less than the value configured. Do not use values in this range for 10G
interfaces.
Related
Commands
rate-shape — shapes traffic output as part of the designated policy.
service-class dot1p-mapping
Configure a service-class criterion based on a dot1p value.
S4820T
Syntax
service-class dot1p-mapping {dot1p0 value | dot1p1 value |
dot1p2 value | dot1p3 value | dot1p4 value| dot1p5 value |
dot1p6 value | dot1p7 value}
Parameters
dot1p0 value ...
dot1p7 value
Enter a dot1p list number and value. The list number range is from 0 to
7. The range is from 0 to 3.
Defaults For each dot1p Priority, the default CoS queue value is:
• dot1p Priority: 0 1 2 3 4 5 6 7
• CoS Queue: 0 0 0 1 2 3 3 3
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To apply dot1p-queue-mapping, use the service-class dynamic dot1p command.
Related
Commands
show qos dot1p-queue-mapping — displays the dot1p priority to queue mapping on the switch.
1095