Reference Guide

service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all interfaces (from
CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode entry.
S4820T
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p
command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class dynamic
dot1p command. The default mapping is as follows:
dot1p Queue ID
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
Command Modes
• INTERFACE
• CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Expanded the command to permit configuration on port channels.
pre-Version
6.1.1.1
Introduced on the E-Series.
1096