Reference Guide

Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Added the DSCP Marking option support on the S-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.5.1.0 Added support for the DSCP Marking option.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
To access this command, enter the class-map command. After the class map is identified,
you can configure the match criteria. For class-map match-any, a maximum of five ACL match
criteria are allowed. For class-map match-all, only one ACL match criteria is allowed.
Related
Commands
class-map — identifies the class map.
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
S4820T
Syntax
match ip dscp dscp-list [[multicast] set-ip-dscp value]
To remove a DSCP value as a match criteria, use the no match ip dscp dscp-list
[[multicast] set-ip-dscp value] command.
Parameters
dscp-list Enter the IP DSCP values that is to be the match criteria. Separate
values by commas — no spaces ( 1,2,3 ) or indicate a list of values
separated by a hyphen (1-3). The range is from 0 to 63.
multicast (OPTIONAL) Enter the keyword multicast to match against
multicast traffic.
NOTE: This option is not supported on C-Series or S-Series.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP DSCP
value. The matched traffic is marked with the DSCP value. The range
is from 0 to 63.
NOTE: This option is not supported on S-Series.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
1102