Reference Guide

Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Added the keyword multicast. Added support for the DSCP
marking
option for the S-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.5.1.0 Added support for the DSCP Marking option.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
To access this command, enter the class-map command. After the class map is identified,
you can configure the match criteria.
The match ip precedence command and the match ip dscp command are mutually
exclusive.
Up to eight precedence values can be matched in one match statement. For example, to
indicate the IP precedence values 0 1 2 3, enter either the match ip precedence 0-3 or
match ip precedence 0,1,2,3 command.
NOTE: Only one of the IP precedence values must be a successful match criterion, not all
of the specified IP precedence values must match.
Related
Commands
class-map — identifies the class map.
match mac access-group
Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
S4820T
Syntax
match mac access-group {mac-acl-name}
Parameters
mac-acl-name Enter a MAC ACL name. Its contents is used as the match criteria in
the class map.
Defaults none
Command Modes CLASS-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
1104