Reference Guide

Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
Aggregate input/output QoS policy applies to all the port ingoing/outgoing traffic. Aggregate
input/output QoS policy can coexist with per queue input/output QoS policies.
1. If only aggregate input QoS policy exists, input traffic conditioning configurations (rate-
police) apply. Any marking configurations in aggregate input QoS policy are ignored.
2. If aggregate input QoS policy and per class input QoS policy coexist, aggregate input QoS
policy preempts per class input QoS policy on input traffic conditioning (rate-police). In
other words, if rate police configuration exists in the aggregate QoS policy, the rate
police configurations in per class QoS are ignored. Marking configurations in per class
input QoS policy still apply to each queue.
Related
Commands
policy-map-input — creates an input policy map.
policy-map-output — creates an output policy map (E-Series Only).
policy-map-input
Create an input policy map.
S4820T
Syntax
policy-map-input policy-map-name [layer2]
To remove an input policy map, use the no policy-map-input policy-map-name
[layer2] command.
Parameters
policy-map-name Enter the name of the policy map in character format (32 characters
maximum).
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class
Map. The default is
Layer 3.
Defaults Layer 3
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
1107