Reference Guide

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Expanded to add support for Layer 2.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The input policy map is used to classify incoming traffic to different flows using class-map, QoS
policy, or incoming packets DSCP. This command enables Policy-Map-Input Configuration
mode (conf-policy-map-in).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS using policy
maps.
service-policy input — applies an input policy map to the selected interface.
policy-map-output
Create an output policy map.
S4820T
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.
Parameters
policy-map-name Enter the name for the policy map in character format (16 characters
maximum).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
1108