Reference Guide

pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
To assign traffic to different flows using QoS policy, use the Output Policy map. This command
enables Policy-Map-Output Configuration mode (conf-policy-map-out).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS using policy
maps.
service-policy output — applies an output policy map to the selected interface.
qos-policy-input
Create a QoS input policy on the router.
S4820T
Syntax
qos-policy-input qos-policy-name [layer2]
To remove an existing input QoS policy from the router, use the no qos-policy-input
qos-policy-name [layer2] command.
Parameters
qos-policy-name Enter the name for the policy map in character format (32 characters
maximum).
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class
Map. The default is
Layer 3.
Defaults Layer 3
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
To specify the name of the input QoS policy, use this command. After the input policy is
specified, rate-police is defined. This command enables Qos-Policy-Input Configuration mode
— (conf-qos-policy-in).
1109