Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T

1111

Command History

This guide is platform-specific. For command information about other platforms, refer to the

relevant

FTOS Command Line Reference Guide

The following is a list of the FTOS version history for this command.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.3.8.0 Introduced on the S4810.

Version 7.4.1.0

and 6.5.3.0

Introduced on the E-Series.

Usage

Information

This command does not uniquely identify a queue, but rather identifies only a set of queues.

The WRED Curve is applied to all eight ingress Multicast queues.

NOTE: The multicast-bandwidth option is not supported on queue ingress. If you

attempt to use the

multicast-bandwidth option, the following reject error message

is generated: % Error:Bandwidth-percent is not allowed for

ingress multicast.

Commands

show queue statistics ingress — displays the ingress queue statistics.

rate-police

Specify the policing functionality on incoming traffic.

S4820T

Syntax

rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-

rate [burst-KB]]

Parameters

kbps Enter the keyword kbps to specify the rate limit in Kilobits per

second (Kbps). Make the following value a multiple of 64. The range is

from 0 to 40000000. The default granularity is Megabits per second

(Mbps).

committed-rate

Enter the bandwidth in Mbps. The range is from 0 to 10000.

burst-KB

(OPTIONAL) Enter the burst size in KB. The range is from 16 to 200000.

The default is 100.

peak

peak-rate

(OPTIONAL) Enter the keyword peak then a number to specify the

peak rate in Mbps. The range is from 0 to 40000. The default is the

same as designated for

committed-rate.

Defaults Burst size is 100KB. peak-rate is by default the same as committed-rate. Granularity

for

committed-rate and peak-rate is Mbps unless you use the kbps option.

Command Modes QOS-POLICY-IN