Reference Guide

Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
rate-shape can be applied only as an aggregate policy. If it is applied as a class-based
policy, rate-shape does not take effect.
On 40-port 10G linecards, if the traffic is shaped between 64 and 1000Kbs, for some values the
shaped rate is much less than the value configured. Do not use values in this range for 10G
interfaces.
Related
Commands
rate shape — shapes traffic output as part of the designated policy.
qos-policy-output — creates a QoS output policy.
service-policy input
Apply an input policy map to the selected interface.
S4820T
Syntax
service-policy input policy-map-name [layer2]
To remove the input policy map from the interface, use the no service-policy input
policy-map-name [layer2] command.
Parameters
policy-map-name Enter the name for the policy map in character format (16 characters
maximum). You can identify an existing policy map or name one that
does not yet exist.
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class
Map. The default is Layer 3.
Defaults Layer 3
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 E-Series Only: Expanded to add support for Layer 2.
1115