Reference Guide

route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of a
configured route-map.
Defaults Disabled. Metric: 1.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
The default route must be present in the switch routing table for the default-
information originate
command to take effect.
default-metric
Change the default metric for routes. To ensure that all redistributed routes use the same metric value, use this
command with the redistribute command.
S4820T
Syntax
default-metric number
To return the default metric to the original values, use the no default-metric command.
Parameters
number Specify a number. The range is from 1 to 16. The default is 1.
Defaults 1
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
1140