Reference Guide

distribute-list out
Configure a filter for outgoing routing updates.
S4820T
Syntax
distribute-list prefix-list-name out [interface | bgp |
connected | ospf | static]
To delete the filter, use the no distribute-list prefix-list-name out
command.
Parameters
prefix-list-name Enter the name of a configured prefix list.
interface (OPTIONAL) Identifies the interface type slot/port as one of the
following:
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to
4094.
connected (OPTIONAL) Enter the keyword connected to filter only directly
connected routes.
ospf (OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
static (OPTIONAL) Enter the keyword static to filter manually configured
routes.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
1144