Reference Guide

Usage
Information
Although the passive interface does not send or receive routing updates, the network on that
interface still includes in RIP updates sent using other interfaces.
Related
Commands
neighbor — enables RIP for a specified network.
network — defines a neighbor.
redistribute
Redistribute information from other routing instances.
S4820T
Syntax
redistribute {connected | static}
To disable redistribution, use the no redistribute {connected | static} command.
Parameters
connected Enter the keyword connected to specify that information from
active routes on interfaces is redistributed.
static Enter the keyword static to specify that information from static
routes is redistributed.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
To redistribute the default route (0.0.0.0/0), configure the default-information
originate command.
Related
Commands
default-information originate — generates a default route for RIP traffic.
1153