Reference Guide

router rip
To configure and enable RIP, enter ROUTER RIP mode.
S4820T
Syntax
router rip
To disable RIP, use the no router rip command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
To enable RIP, assign a network address using the network command.
Example
FTOS(conf)#router rip
FTOS(conf-router_rip)#
Related
Commands
network — enables RIP.
exit — returns to CONFIGURATION mode.
show config
Display the changes you made to the RIP configuration. The default values are not shown.
S4820T
Syntax
show config
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
1156