Reference Guide

• configure for CONFIGURATION mode
• exec for EXEC mode
• interface for INTERFACE modes
• line for LINE mode
• route-map for ROUTE-MAP mode
• router for ROUTER OSPF, ROUTER RIP, ROUTER ISIS and
ROUTER BGP modes
level level Enter the keyword level then a number for the access level. The
range is from 0 to 15.
Level 1 is EXEC mode and Level 15 allows access to all CLI modes and
commands.
reset Enter the keyword reset to return the security level to the default
setting.
command Enter the command’s keywords to assign the command to a certain
access level. You can enter one or all of the keywords.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
To define a password for the level to which you are assigning privilege or access, use the
enable password command.
privilege level (LINE mode)
Change the access level for users on the terminal lines.
S4820T
Syntax
privilege level level
To delete access to a terminal line, use the no privilege level level command.
Parameters
level level
Enter the keyword level then a number for the access level. The
range is from 0 to 15.
1200