Reference Guide

example, to create the password abcd]e, you type “abcd CNTL v ]e”. When the
password is created, you do not use the CNTL + v key combination and enter
“abcd]e”.
NOTE: The question mark (?) and the tilde (~) are not supported characters.
Related
Commands
show running-config — views the current configuration.
privilege level (CONFIGURATION mode) — controls access to the command modes within the
switch.
enable restricted
Allows Dell Networking technical support to access restricted commands.
S4820T
Syntax
enable restricted [encryption-type] password
To disallow access to restricted commands, use the no enable restricted command.
Parameters
encryption-type
(OPTIONAL) Enter the number 7 as the encryption type.
Enter 7 followed a text string as the hidden password. The text string
must be a password that was already encrypted by a Dell Networking
router.
Use this parameter only with a password that you copied from the
show running-config file of another Dell Networking router.
password Enter a text string, up to 32 characters long, as the clear text
password.
Defaults Not configured.
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
Only Dell Networking Technical Support staff use this command.
1206