Reference Guide

password-attributes
Configure the password attributes (strong password).
S4820T
Syntax
password-attributes [min-length number] [max-retry number]
[character-restriction [upper number] [lower number] [numeric
number] [special-char number]]
To return to the default, use the no password-attributes [min-length number]
[max-retry number] [character-restriction [upper number] [lower
number] [numeric number] [special-char number]] command.
Parameters
min-length
number
(OPTIONAL) Enter the keywords min-length then the number of
characters. The range is from 0 to 32 characters.
max-retry number (OPTIONAL) Enter the keywords max-retry then the number of
maximum password retries. The range is from 0 to 16.
character-
restriction
(OPTIONAL) Enter the keywords character-restriction to
indicate a character restriction for the password.
upper number (OPTIONAL) Enter the keyword upper then the upper number. The
range is from 0 to 31.
lower number (OPTIONAL) Enter the keyword lower then the lower number. The
range is from 0 to 31.
numeric number (OPTIONAL) Enter the keyword numeric then the numeric number.
The range is from 0 to 31.
special-char
number
(OPTIONAL) Enter the keywords special-char then the number
of special characters permitted. The range is from 0 to 31.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.3.1.0 Introduced on the E-Series.
1210