Reference Guide

Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Authentication key length increased to 42 characters.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
The key configured on the switch must match the key configured on the RADIUS server
daemon.
If you configure the key parameter in the radius-server host command, the key
configured with the
radius-server key command is the default key for all RADIUS
communications.
Related
Commands
radius-server host — configures a RADIUS host.
radius-server retransmit
Configure the number of times the switch attempts to connect with the configured RADIUS host server before declaring
the RADIUS host server unreachable.
S4820T
Syntax
radius-server retransmit retries
To configure zero retransmit attempts, use the no radius-server retransmit
command.
To return to the default setting, use the radius-server retransmit 3 command.
Parameters
retries Enter a number of attempts that FTOS tries to locate a RADIUS server.
The range is from zero (0) to 100. The default is 3 retries.
Defaults 3 retries
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
1220