Reference Guide

dot1x max-eap-req
Configure the maximum number of times an extensive authentication protocol (EAP) request is transmitted before the
session times out.
S4820T
Syntax
dot1x max-eap-req number
To return to the default, use the no dot1x max-eap-req command.
Parameters
number Enter the number of times an EAP request is transmitted before a
session time-out. The range is from 1 to 10. The default is 2.
Defaults 2
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
Related
Commands
interface range — configures a range of interfaces.
dot1x port-control
Enable port control on an interface.
S4820T
Syntax
dot1x port-control {force-authorized | auto | force-
unauthorized}
Parameters
force-authorized Enter the keywords force-authorized to forcibly authorize a
port.
auto Enter the keyword auto to authorize a port based on the 802.1X
operation result.
force-
unauthorized
Enter the keywords force-unauthorized to forcibly de-
authorize a port.
Defaults none
1230