Reference Guide

dot1x reauthentication
Enable periodic re-authentication of the client.
S4820T
Syntax
dot1x reauthentication [interval seconds]
To disable periodic re-authentication, use the no dot1x reauthentication
command.
Parameters
interval seconds (Optional) Enter the keyword interval then the interval time, in
seconds, after which re-authentication is initiated. The range is from
1 to 31536000 (1 year). The default is
3600 (1 hour).
Defaults 3600 seconds (1 hour)
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
Related
Commands
interface range — configures a range of interfaces.
dot1x reauth-max
Configure the maximum number of times a port can re-authenticate before the port becomes unauthorized.
S4820T
Syntax
dot1x reauth-max number
To return to the default, use the no dot1x reauth-max command.
Parameters
number Enter the permitted number of re-authentications. The range is from 1
to 10. The default is 2.
Defaults 2
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
1232