Reference Guide

ip ip-address Enter the keyword ip then the IP address that the server is leasing.
interface type
Enter the keyword interface then the type of interface to which
the host is connected.
• For an 10/100 Ethernet interface, enter the keyword
fastethernet.
• For a Gigabit Ethernet interface, enter the keyword
gigabitethernet.
• For a ten-Gigabit Ethernet interface, enter the keyword
tengigabitethernet.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE.
slot/port Enter the slot and port number of the interface.
lease time Enter the keyword lease then the amount of time the IP address is
leased. The range is from 1 to 4294967295.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Related
Commands
show ip dhcp snooping — displays the contents of the DHCP binding table.
ip dhcp snooping database
Delay writing the binding table for a specified time.
S4820T
Syntax
ip dhcp snooping database write-delay minutes
Parameters
minutes The range is from 5 to 21600.
Defaults none
1252