Reference Guide

Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
sFlow is disabled by default. In addition to this command, sFlow needs to be enable on
individual interfaces where sFlow sampling is desired.
Related
Commands
sflow enable (Interface) — enables sFlow on interfaces.
sflow enable (Interface)
Enable sFlow on interfaces.
S4820T
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on S-Series Stacking.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
When you enable sFlow on an interface, flow sampling is done on any traffic going out of the
interface.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow configuration from
the LAG port.
Related
Commands
sflow enable (Global) — turns sFlow on globally.
1266