Reference Guide

• temperature
For the snmp notification-type, enter one of the following optional
parameters:
• authentication
• coldstart
• linkdown
• linkup
Defaults Not enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.1(0.0) Added support for copy-config and ecmp traps.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.1.0 Added support for VRRP traps.
Version 7.6.1.0 Added support for STP and xSTP traps. Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
FTOS supports up to 16 SNMP trap receivers.
For the cam-utilization notification option, the system generates syslogs and SNMP
traps when the L3 host table or route table utilization goes above the threshold. This applies to
the
S4820T only.
If you do not configure this command, no traps controlled by this command are sent. If you do
not specify a notification-type and notification-option, all traps are enabled.
Related
Commands
snmp-server community — enables SNMP and sets the community string.
snmp-server engineID
Configure the name for both the local and remote SNMP engines on the router.
S4820T
Syntax
snmp-server engineID [local engineID] [remote ip-address udp-
port port-number engineID]
To return to the default, use the no snmp-server engineID [local engineID]
[remote ip-address udp-port port-number engineID] command.
1281