Reference Guide

access access-
list-name
(Optional) Enter the standard IPv4 access list name (a string up to 16
characters long).
ipv6 access-list-
name
(Optional) Enter the keyword ipv6 then the IPv6 access list name (a
string up to 16 characters long).
access-list-name
ipv6 access-list-
name
(Optional) Enter both an IPv4 and IPv6 access list name.
Defaults As above.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.10.2 Added support for the access parameter.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
The following Example specifies the group named harig as a version 3 user requiring both
authentication and encryption and read access limited to the read named rview .
NOTE: The number of configurable groups is limited to 16 groups.
Example
FTOS#conf
FTOS(conf)# snmp-server group harig 3 priv read rview
FTOS#
Related
Commands
show snmp group — displays the group name, security model, view status, and storage type of
each group.
show running-config — displays the SNMP running configuration.
snmp-server host
Configure the recipient of an SNMP trap operation.
S4820T
Syntax
snmp-server host ip-address | ipv6-address [traps | informs]
[version 1 | 2c | 3] [auth | no auth | priv] [community-string]
[udp-port port-number] [notification-type]
1284