Reference Guide

• For VLAN interface, enter the keyword vlan then a number
from 1 to 4094.
Defaults The IP address assigned to the management interface is the default.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
To enable this snmp-server trap-source command, configure an IP address on the
interface and enable the interface configured as an SNMP trap source.
Related
Commands
snmp-server community — sets the community string.
snmp-server user
Configure a new user to an SNMP group.
S4820T
Syntax
snmp-server user name {group_name remote ip-address udp-port
port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-
password] [priv des56 priv password] [access access-list-name |
ipv6 access-list-name | access-list-name ipv6 access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name
{group_name remote ip-address udp-port port-number} [1 | 2c |
3] [encrypted] [auth {md5 | sha}
auth-password] [priv des56
priv password] [access access-list-name | ipv6 access-list-name
| access-list-name ipv6 access-list-name] command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on the host
that connects to the agent.
group_name Enter a text string (up to 20 characters long) as the name of the group.
The following groups are created for mapping to read/write
community/security-names (defaults):
1289