Reference Guide

The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
When you use the no logging on command, messages are logged only to the console.
Related
Commands
logging — enables logging to the Syslog server.
logging buffered — sets the logging buffered parameters.
logging console — sets the logging console parameters.
logging monitor — sets the logging parameters for the terminal connections.
logging source-interface
Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog server.
S4820T
Syntax
logging source-interface interface
To disable this command and return to the default setting, use the no logging source-
interface
command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For Loopback interfaces, enter the keyword loopback then
a number from zero (0) to 16383.
• For the management interface on the RPM, enter the keyword
ManagementEthernet then the slot/port information. The
slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. Tthe range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For VLAN interface, enter the keyword vlan then a number
from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
1303