Reference Guide

Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
When you enable logging synchronous, unsolicited messages appear between
software prompts and outputs. Only the messages with a severity at or below the set level are
sent to the console.
If the message queue limit is reached on a terminal line and messages are discarded, a system
message appears on that terminal line. Messages may continue to appear on other terminal
lines.
Related
Commands
logging on — enables logging.
logging trap
Specify which messages are logged to the Syslog server based the message severity.
S4820T
Syntax
logging trap [level]
To return to the default values, use the default logging trap command.
To disable logging, use the no logging trap command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following parameters:
emergencies, alerts, critical, errors, warnings,
notifications, informational, or debugging. The default
is 6 or informational.
Defaults 6 or informational
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
1305