Reference Guide

redundancy protocol
Enable hitless failover for a protocol.
S4820T
Syntax
redundancy protocol
Protocols
lacp Enter the LACP protocol
xstp Enter one of the following protocols: STP, RSTP, MSTP, PVST.
Defaults Not enabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.7.1.0 Introduced on the S-Series.
reset stack-unit
Reset any designated stack member except the management unit (master unit).
S4820T
Syntax
reset stack-unit hard
Parameters
stack-unit Enter the stack-unit number. For the S4820T, the range is from 0 to 11.
hard Reset the stack unit if the unit is in a problem state.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
1319