Reference Guide

The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.7.1.0 Introduced on the S-Series.
Usage
Information
To modify your results, use the show redundancy [pipe] command, as follows:
• except — show only text that doesn not match a pattern.
• find — search for the first occurrence of a pattern.
• grep — show only text that matches a pattern.
• no-more — do not paginate the output.
• save — save the output to a file.
Example
FTOS#show redundancy
FTOS#show redundancy
-- SSeries Redundancy Configuration --
------------------------------------------------
Auto reboot : Enabled
-- Stack-unit Status --
------------------------------------------------
Mgmt ID: 0
Stack-unit ID: 0
Stack-unit Redundancy Role: Primary
Stack-unit State: Active
Stack-unit SW Version: 7.7.1.0
Link to Peer: Up
-- PEER Stack-unit Status --
------------------------------------------------
Stack-unit State: Standby
Peer stack-unit ID: 1
Stack-unit SW Version: 7.7.1.0
-- Stack-unit Redundancy Configuration --
------------------------------------------------
Primary Stack-unit: mgmt-id 0
Auto Data Sync: Full
Failover Type: Hot Failover
Auto reboot Stack-unit: Enabled
Auto failover limit: 3 times in 60 minutes
-- Stack-unit Failover Record --
------------------------------------------------
Failover Count: 0
Last failover timestamp: None
Last failover Reason: None
Last failover type: None
-- Last Data Block Sync Record: --
------------------------------------------------
Stack Unit Config: succeeded Jul 11 2012 09:42:35
Start-up Config: succeeded Jul 11 2012 09:42:35
Runtime Event Log: succeeded Jul 11 2012 09:42:35
1321