Reference Guide

Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID. The range is from 0 to 15.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Reset command mode from EXEC to CONFIGURATION.
Version 8.3.10.2 Introduced on the S4810.
Usage
Information
The following message displays to confirm the command.
Setting ports Fo 0/60 as stack group will make their interface
configs obsolete after a reload.[confirm yes/no]: If “y” is
entered, all non-default configurations on any member ports of
the current stack group will be removed when the unit is
rebooted.
NOTE: Any scripts used to streamline the stacking configuration process must be updated
to reflect the Command Mode change from EXEC Privilege to CONFIGURATION to allow
the scripts to work correctly.
upgrade system stack-unit
Copy the boot image or FTOS from the management unit to one or more stack members.
S4820T
Syntax
upgrade {boot | system} stack-unit {all | 0-11 | A | B}
Parameters
boot Enter the keyword boot to copy the boot image from the
management unit to the designated stack members.
system Enter the keyword system to copy the FTOS image from the
management unit to the designated stack members.
stack-unit Enter the stack-unit number. For the S4820T, the range is from 0 to 11.
all Enter the keyword all to copy the designated image to all stack
members.
0-11 Enter the unit ID of the stack member to which to copy the designated
image.
1326