Reference Guide

storm-control unknown-unicast (Interface)
Configure percentage of unknown-unicast traffic allowed on an interface (ingress only).
S4820T
Syntax
storm-control unknown-unicast [percentage decimal_value in] |
[wred-profile name]] [packets_per_second in]
To disable unknown-unicast storm control on the interface, use the no storm-control
unknown-unicast [percentage decimal_value in] | [wred-profile
name]] [packets_per_second in] command.
Parameters
percentage
decimal_value [in
| out]
E-Series Only: Enter the percentage of broadcast traffic allowed in or
out of the network. Optionally, you can designate a decimal value
percentage, for example, 55.5%.
The percentage is from 0 to 100:
• 0% blocks all related traffic.
• 100% allows all traffic into the interface.
The decimal range is from 0.1 to 0.9.
wred-profile
name
E-Series Only: (Optionally) Enter the keywords wred-profile
followed by the profile name to designate a wred-profile.
packets_per_sec
ond in
C-Series and S-Series Only: Enter the packets per second of
broadcast traffic allowed into the network. The range is from 0 to
33554431.
Defaults none
Command Modes INTERFACE (conf-if- interface-slot/port )
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 E-Series Only: Added the percentage decimal value option.
Version 6.5.1.0 Introduced on the E-Series.
1336