Reference Guide

The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
Save your changes before resetting the system or all your changes will be lost.
save
Save configurations created in uBoot.
S4820T
Syntax
save
Command Modes uBoot
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
Save your changes before resetting the system or all your changes will be lost.
setenv
Configure system settings.
S4820T
Syntax
setenv [gatewayip address | primary_image f10boot location |
secondary_image f10boot location | default_image f10boot
location | ipaddre address | ethaddr address | enablepwdignore
| stconfigignore]
Parameters
gatewayip
address
Enter the IP address for the default gateway.
primary_image Enter the keywords primary_image to configure the boot
parameters used in the first attempt to boot FTOS.
1369