Reference Guide

secondary_image Enter the keywords secondary_image to configure boot
parameters used if the primary operating system boot selection is not
available.
default_image Enter the keywords default_image to configure boot parameters
used if the secondary operating system boot parameter selection is
not available.
NOTE: The default location should always be the internal flash
device (flash:), and a verified image should be stored there.
location Enter the location of the image file to be loaded. When using this
command, the keyword f10boot must precede the location. For
example,
primary_image f10boot tftp://
10.10.10.10/server.
ipaddr Enter the keyword ippaddr to configure the system management IP
address.
ethaddr Enter the keyword ethaddr to configure system management MAC
address.
address Enter the IP address in standard IPv4 format and the MAC address in
standard MAC format.
enablepwdignore Enter the keywords enableprdignore true to reload the
system software without the enable password configured.
stconfigignore Enter the keywords stconfigignore true to ignore the startup
configuration file when reloading the system.
Command Modes uBoot
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
1370