Reference Guide

undebug all
Disable all debug operations on the system.
S4820T
Syntax
undebug all
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command
virtual-ip
Configure a virtual IP address for the active management interface. You can configure virtual addresses both for IPv4
and IPv6 independently.
S4820T
Syntax
virtual-ip {ipv4-address | ipv6-address}
To return to the default, use the no virtual-ip {ipv4-address | ipv6-
address} command.
Parameters
ipv4-address Enter the IP address of the active management interface in a dotted
decimal format (A.B.C.D.).
ipv6-address Enter an IPv6 address of the active management interface, in the
x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
138