Reference Guide

Related
Commands
• downstream — assigns a port or port-channel to the uplink-state group as a
downstream interface.
• uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
enable
Enable uplink state group tracking for a specific UFD group.
S4820T
Syntax
enable
To disable upstream-link tracking without deleting the uplink-state group, use the no enable
command.
Defaults Upstream-link tracking is automatically enabled in an uplink-state group.
Command Modes UPLINK-STATE-GROUP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T
Version 8.3.12.0 Introduced on the S4810.
Version 8.4.2.3 Introduced on the S-Series S50.
Related
Commands
• uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
show running-config uplink-state-group
Display the current configuration of one or more uplink-state groups.
S4820T
Syntax
show running-config uplink-state-group [group-id]
Parameters
group-id Displays the current configuration of all uplink-state groups or a
specified group. The valid group-id values are from 1 to 16.
1382