Reference Guide

member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack compatible
command in its configuration.
S4820T
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface
command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabyte Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
Defaults Not configured.
Command Modes CONF-IF-VLAN
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
E-Series original
Command
Usage
Information
You must enable the stackable VLAN (using the vlan-stack compatible command) on
the VLAN prior to adding a member to the VLAN.
Related
Commands
vlan-stack compatible — enables stackable VLAN on a VLAN.
1392