Manualshelf

Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T
1391139213931394139513961397139813991400
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
E-Series original
Command
Usage
Information
Prior to enabling this command, to place the interface in Layer 2 mode, enter the
switchport command.
To remove the access port designation, remove the port (using the no member
interface command) from all stackable VLAN enabled VLANs.
vlan-stack compatible
Enable the stackable VLAN feature on a VLAN.
S4820T
Syntax
vlan-stack compatible
To disable the Stackable VLAN feature on a VLAN, use the no vlan-stack compatible
command.
Defaults Not configured.
Command Modes CONF-IF-VLAN
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant
FTOS Command Line Reference Guide
.
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
E-Series original
Command
Usage
Information
Prior to disabling the stackable VLAN feature, remove the members.
1394