Reference Guide

vlt All VLT LACP members
become switchports
multicast peer-routing timeout
Configure the time for a VLT node to retain synced multicast routes or synced multicast outgoing interface (OIF) after a
VLT peer node failure.
S4820T
Syntax
multicast peer-routing timeout value
To restore the default value, use the no multicast peer-routing timeout
command.
Parameters
value Enter the timeout value in seconds. The range is from 1 to 1200. The
default is 150.
Command Modes VLT DOMAIN (conf-vlt-domain)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
peer-link port-channel
Configure the specified port channel as the chassis interconnect trunk between VLT peers in the domain.
S4820T
Syntax
peer-link port-channel port-channel-number {peer-down-vlan vlan
id}
Parameters
port-channel-
number
Enter the port-channel number that acts as the interconnect trunk.
peer-down-vlan
vlan id
Enter the keyword peer-down-vlan then a VLAN ID to configure
the VLAN that the VLT peer link uses when the VLT peer is down.
Defaults Not configured.
Command Modes VLT DOMAIN
1405