Reference Guide

Parameters
value Enter the timeout value in seconds. The range is from 1 to 65535. The
default value is 0 (no timeout).
Command Modes VLT DOMAIN (conf-vlt-domain)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
Usage
Information
When the timer expires, the software checks to see if the VLT peer is now available. If the VLT
peer is not available, peer-routing is disabled on that peer.
primary-priority
Assign the priority for master election among VLT peers.
S4820T
Syntax
[no] primary-priority
Parameters
value To configure the primary role on a VLT peer, enter a lower value than
the priority value of the remote peer. The range is from 1 to 65535.
Default 32768
Command Modes VLT DOMAIN
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
After you configure the VLT domain on each peer switch on both sides of the interconnect
trunk, by default, the FTOS software elects a primary and secondary VLT peer device. To
reconfigure the primary role of VLT peer switches, use the priority command.
1407