Reference Guide

Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
This command applies to a single interface. When used with the vrrp delay reload CLI,
the later timer rules the VRRP enabling. For example, if vrrp delay reload is 600 and the
vrrp delay minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all
interfaces that are up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface.
Related
Command
vrrp delay reload — sets the delay time for VRRP initialization after a system reboot.
vrrp delay reload
Set the delay time for VRRP initialization after a system reboot.
S4820T
Syntax
vrrp delay reload seconds
Parameters
seconds Enter the number of seconds for the delay. The range is from 0 to 900
(0 indicates no delay).
Defaults 0
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
This command applies to all the VRRP configured interfaces on a system. When used with the
vrrp delay minimum CLI, the later timer rules the VRRP enabling. For example, if vrrp
delay reload is 600 and the vrrp delay minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all
interfaces that are up and configured for VRRP.
1431