Reference Guide

Parameters
interface Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
vrid (OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all Enter the keyword all to enable debugging of all VRRP groups.
bfd Enter the keyword bfd to enable debugging of all VFFP BFD
interactions.
database Enter the keyword database to display changes related to group,
prefix, and interface entries in the VRRP table.
packets Enter the keyword packets to enable debugging of VRRP control
packets.
state Enter the keyword state to enable debugging of VRRP state
changes
timer Enter the keyword timer to enable debugging of the VRRP timer.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.10.0 Introduced on the S4810.
Version 8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series. Support
was added for IPv6 VRRP groups in non-default VRF instances.
Version 8.3.2.0 Introduced on the E-Series TeraScale.
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
show vrrp ipv6
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the FTOS returns No Active VRRP
group
.
S4820T
Syntax
show vrrp ipv6 [vrid] [interface] [brief]
1434