Reference Guide

Parameters
vrid (OPTIONAL) Enter the virtual router identifier for the VRRP group to
view only that group. The range is from 1 to 255.
interface Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For SONET interfaces, enter the keyword sonet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information
on the VRRP groups.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.10.0 Introduced on the S4810.
Version 8.3.2.0 Introduced on the E-Series TeraScale.
Usage
Information
The following describes the show vrrp ipv6 command shown in the following example.
Line Beginning with Description
GigabitEthernet... Displays the Interface, the VRRP group ID, and the network address.
If the interface is no sending VRRP packets, 0.0.0.0 appears as the
network address.
VRF VRF instance to which the interface (on which the VRRP group is
configured) belongs.
State: master... Displays the interface’s state:
• Na/If (not available).
• master (MASTER virtual router).
• backup (BACKUP virtual router).
the interface’s priority and the IP address of the MASTER.
Hold Down:... This line displays additional VRRP configuration information:
• Hold Down displays the hold down timer interval in seconds.
1435