Reference Guide

pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s virtual
address with same IP address as the interface’s primary IP address and change the priority of
the VRRP group to 255.
If you set the priority command to 255 and the virtual-address is not equal to the
interface’s primary IP address, an error message appears.
show config
View the non-default VRRP configuration.
S4820T
Syntax
show config [verbose]
Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP group
configuration information, including defaults.
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Example
FTOS(conf-if-vrid-4)#show con
vrrp-group 4
virtual-address 119.192.182.124
!
1442